Connection with iLO cannot be established.
When you try to connect to ILO, you get an error message stating “Connection with iLO cannot be established.” If any changes was made to the network configurations, you may… Read more »
HP (Servers/products)
When you try to connect to ILO, you get an error message stating “Connection with iLO cannot be established.” If any changes was made to the network configurations, you may… Read more »
If you are trying to access an iLO behind a firewall, there are some TCP ports that need to be opened on the firewall. Here is a list of the… Read more »
You can also SSH into the ILO and examine the command-line options. After Connecting to ILO using Putty. “power help” will list the options available. power on – Turn the… Read more »
Host was not reachable on network. When checked on ILO server is up and running. When I try to ping the server its unresponsive.Host is a blade server, hence suspected… Read more »
Recently, one of the blade server was re imaged with a new name. However, new server name was not getting reflected under the devices. Hence, below steps were followed to… Read more »
HP ILO sometime face hung-up issues and freezes on the interface. In this case we would need to reset the ILO controller to fix the issue. ILO can be easily… Read more »
Most often, when a case is raised with HP support team, we are asked to generate logs and send it to HP. Recently, I had an issue with an ESX… Read more »
Recently, we upgraded firmware on all our blade enclosures and servers. This time we got stuck with the Citrix servers. We were informed that the Citrix applications are not working… Read more »
What you can do is to SSH into the chassis via the OA address/ip and then, issue the following command to reset the specific blade. Just insert the bay number… Read more »
It is very difficult sometimes to take the ILO Homepage of a remote computer. Site loads very slow or the page is not supported and sometimes the compatibility issue. However,… Read more »