How to reset blade slot in HP C7000?

What you can do is to SSH into the chassis via the OA address/ip and then, issue the following command to reset the specific blade. Just insert the bay number of the blade that you would need to.

reset server <bay #>

This command is almost equivalent to completely removing the server and reinserting back. When you issue this command, ILO will also get disrupted for few seconds.

Thanks,
WintelAdmin

 

Celebrating 3 Years

It all started back on June, 2010. over the last three years, this has been a wonderful platform to share the knowledge with wonderful people out there. Thanks for all your likes, comments, suggestions and support.

Special thanks to SpeedHost Support Team,  for invaluable support during crisis, maybe six months back when the site got complete crashed.

Thanks,
WintelAdminStepped into 4th.